MotorFish
Turn your stepper motors into precisely controlled servos
- Can drive a stepper or 2 brushed motors
- 2.5 Ampere max per phase
- Embedded 12 bit (4096 steps) magnetic encoder
- It binds directly on motor's backside
- Nema17 format, can be mounted on bigger motors with an adapter
- Powered from 9 di 42 volt
- The on-board 32 bit microcontroller can be programmed to handle any users needs
- The onboard I2C allow easy remote control and setting
- Programmable via USB interface with the Arduino IDE or by ICSP connector with MPLAB IDE and PicKit3
- Standard step/dir stepper interface
- "locked" output to signal if required position is reached
- 4 user-programmable LEDs
- 4 user I/O, 2 of which can also be used as a standard serial port